ProPower 2000
Supreme Audio Power AC Regeneration With Battery Backup
The ProPower 2000 battery back-up power re-generator quietly generates a new, clean, 120 volt 60 cycle sine wave right beside your audio or home theater system, so there is no opportunity for outside influences to introduce unwanted waveform distortions. Your amplifier will play louder than if it was plugged into the wall outlet, delivering more slam on low frequencies and all the dynamics you’ve probably been missing. The 2000′s output of 2100 watts is more than enough to power dual monoblock, bi-amped, or tri-amped systems plus ancillary equipment.. The 2000′s on-board battery system provides the reference voltage, as well as total isolation for your system from the utility power, regardless of whats occurring on the utility line.
Features
2000 VA/1400 watts continuous load, 2100 watts short duration, 4200 watts peak
16.6 amps RMS, 25 amps short duration, 50 amps peak
10 Hubbell 5-15R outlets / 2 hour battery back-up
20 amp input locking power cord included
Designed for high power systems
ProPower 2000 Specifications
Electrical Input: Nominal Voltage 220/230/240
Voltage Range: 160 - 275V
Frequency: 50 / 60 Hz Auto-sensing
Frequency range: 45-65 Hz
Input Connection: IEC 320-C19 Input receptacle (20 amp)
Electrical Output: output Voltage 220/230/240
Voltage Regulation: ±3% of nominal
Frequency Regulation: ±.1 Hz
Efficiency: 89-92% depending on load
Output receptacles: (10) Hubbell NEMA 5-15R
Physical Characteristics:
Floor or Rack mountable (racking hardware included)
Dimensions: 5.25″ H x 17″ W x 22.5″ D. (130x432x570mm)
Weight: 80 lbs (36 kg)
Environmental and Safety
UL and CSA
EMC monitors: FCC Class B and VCCI Class II
Surge Supression: IEEE / ANSI C62.41 Category B (formerly 587)
Ambient Operating Temp: 32 – 90°F (0 – 32°C)
Audible noise: >17 dBA
Relative humidity: 0 to 90% non-condensing
Additional Features
F-Type (coax) surge protection
Phone line surge protection: 1 line input, 2 lines output (on power strip option)
RJ 45 Transient protector: Input and output jack for RJ-45 cable protection,
UL497A tested (on power strip option)
Automatic bypass on sustained overload or AVPS failure
Diagnostics: Full system self-test on power up
